yes, please send the directions, either pm, email, or post
I'll try my best to explain it here... I'm sure you can find better ways of building it...
1. buy 10 inch pvc pipe, redwood 4x2 size, screws, concrete post mix (fast drying product...like 5 minutes)
2. cut the 10 inch pvc pipe about 1 ft long.
3. dig the holes about 1 ft deep
4. put the pvc pipe in the hole and level the pvc pipe
5. cover the surrounding with the dirt and pound it down so it doesn't move.
6. add 1 inch of concrete mix inside the pipe and then add water....and stir it up for 1 minute.
7. add the redwood post in the center of the pvc pipe.
8. add more concrete and water and mix again. repeat the process.
9. make sure to level the post with every mix so it doesn't move.
10. repeat the process above for all the posts.
11. after all posts are aligned, measure about 5 ft from bottom to top. mark the measurement on every post.
12. user the miter saw to cut the square beam for support for each post. Screw all 4 corners around the post together. This allow me to put a wood on top of the square by myself. In some areas, a clamp comes in handy.
13. now, start measuring and cutting all the woods on top with screws.
14. I was picky so I was leveling everything I did to make sure it was straight
15. at the end, I bought some bee wax from homedepot and applied it to the wood.
16. The purpose of the top layer wood is to add a clear poly sheet on top during the winter to help it from the frost. (very important in my area to protect it from winter frost or else it's dead).
I think that's pretty much it. The rest is all about cosmetics...depending on how you want it to look.
I hope that gives you an idea to start on your trellis